|
In computer networking, MAC flooding is a technique employed to compromise the security of network switches. Switches maintain a MAC Table that maps individual MAC addresses on the network to the physical ports on the switch. This allows the switch to direct data out of the physical port where the recipient is located, as opposed to indiscriminately broadcasting the data out of all ports as a hub does. The advantage of this method is that data is bridged exclusively to the network segment containing the computer that the data is specifically destined for. In a typical MAC flooding attack, a switch is fed many Ethernet frames, each containing different source MAC addresses, by the attacker. The intention is to consume the limited memory set aside in the switch to store the MAC address table. The effect of this attack may vary across implementations, however the desired effect (by the attacker) is to force legitimate MAC addresses out of the MAC address table, causing significant quantities of incoming frames to be flooded out on all ports. It is from this flooding behavior that the MAC flooding attack gets its name, and it is this behavior which allows the MAC flooding attack to be used as more than a simple denial-of-service attack against the switching infrastructure. After launching a successful MAC flooding attack, a malicious user could then use a packet analyzer to capture sensitive data being transmitted between other computers, which would not be accessible were the switch operating normally. The attacker may also follow up with an ARP spoofing attack which will allow them to retain access to privileged data after switches recover from the initial MAC flooding attack. ==Counter measures== To prevent MAC flooding attacks, network operators usually rely on the presence of one or more features in their network equipment: * With a feature often called "port security" by vendors, many advanced switches can be configured to limit the number of MAC addresses that can be learned on ports connected to end stations. A smaller table of "secure" MAC addresses is maintained in addition to (and as a subset to) the traditional "MAC address table." * Many vendors allow discovered MAC addresses to be authenticated against an authentication, authorization and accounting (AAA) server and subsequently filtered. * Implementations of IEEE 802.1X suites often allow packet filtering rules to be installed explicitly by an AAA server based on dynamically learned information about clients, including the MAC address. * Security features to prevent ARP spoofing or IP address spoofing in some cases may also perform additional MAC address filtering on unicast packets, however this is an implementation-dependent side-effect. * Additional security measures are sometimes applied along with the above to prevent normal unicast flooding for unknown MAC addresses. This feature usually relies on the "port security" feature to retain all "secure" MAC addresses for at least as long as they remain in the ARP table of layer 3 devices. Hence, the aging time of learned "secure" MAC addresses is separately adjustable. This feature prevents packets from flooding under normal operational circumstances, as well as mitigating the effects of a MAC flood attack. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「MAC flooding」の詳細全文を読む スポンサード リンク
|